Launching soon. This site is informational for now, and Capitol Garage Door is not booking work yet.

Garage Door Spring Replacement and Repair in Sacramento

Not a licensed contractor.

Garage door spring replacement is the most common garage door repair in the Sacramento region, and it usually starts with a loud bang from the garage. If your door suddenly will not lift, or the opener strains and the door only rises a few inches, a broken spring is the first thing to suspect. This page explains how to tell, what is safe to do, what a spring repair involves, and what it typically costs here. Capitol Garage Door is an owner-operated garage door business in Wilton that is launching soon.

Launching soon. Capitol Garage Door is not booking work yet. Tell us your town and what your garage door is doing, and you will hear from us when we open.

Torsion spring mounted above a residential garage door

Signs your garage door spring is broken

  • A sharp bang, like a firecracker, came from the garage while nobody was using the door.
  • The opener runs, but the door lifts a few inches and stops, or does not move at all.
  • You can see a gap of a few inches in the coiled spring on the bar above the door.
  • The door looks crooked, or one side rises before the other.
  • The door feels extremely heavy when you try to lift it by hand.
  • The door drops quickly instead of settling down gently.
  • One or both lift cables hang loose or have come off their drums.

Most homes in the region use torsion springs, which sit on a steel bar right above the door opening. Some older homes and lighter single-car doors use extension springs, which stretch along the horizontal tracks on each side. Both kinds break, and both should be handled by someone with the right tools.

Why garage door springs break

A spring does the real lifting. A two-car steel door can weigh well over a hundred pounds, and the spring carries nearly all of it every time the door moves.

Cycle wear. Standard springs are built for a limited number of open-and-close cycles. Families who use the garage as the main way in and out can wear through a spring years sooner than expected.

Heat, dust and dryness. Long valley summers and dry, dusty air wear away lubrication, and steel that runs dry develops friction and surface rust. That shortens spring life.

Wrong size from the start. Some springs were never matched to the door’s weight. An undersized spring works harder on every cycle and fails early.

The second spring is close behind. On doors with two springs, both were usually installed together and have the same wear. When one goes, the other often follows.

Why spring replacement is not a do-it-yourself job

A wound torsion spring stores a large amount of energy. Unwinding or winding it without proper winding bars, matched parts and practice can cause serious injury. Videos make it look quick. It is the one garage door job we ask every homeowner to leave alone.

With a broken spring, the door is also unpredictable. If it is partly open, it can drop with no warning.

What to do right now

  1. Stop using the opener. It is not designed to lift the full weight of the door and can strip its gear trying.
  2. Leave the door where it is. If it is closed, keep it closed. If it is partly open, keep people and pets out from under it.
  3. Do not pull the red emergency release on a door that is partly open. The door can fall.
  4. Do not touch the spring, the cables or the bottom brackets. They are under tension.
  5. Lock the door between the garage and the house if the garage door is stuck open.
  6. Take a photo of the spring area so a technician can see whether you have one spring or two and where it broke.

What a garage door spring repair involves

  1. Secure the door with clamps so it cannot move during the work.
  2. Measure and match. The door’s weight and height and the wire size, length and inside diameter of the old spring determine the new one. A correctly sized spring is what makes the door balance.
  3. Replace the spring or springs. On a two-spring door, replacing both is usually the better value, because the remaining spring has the same wear. That choice stays with the homeowner.
  4. Check related parts. Cables, drums, center and end bearings, and rollers often wear alongside springs.
  5. Balance and test. A balanced door stays put when lifted halfway by hand. After balancing, the opener force settings, safety sensors and auto-reverse are checked.

Most spring replacements take about 45 minutes to an hour and a half on site.

What affects the cost of spring replacement

  • Spring type. Torsion springs above the door and extension springs along the tracks use different parts and setups.
  • One spring or two. Many doors have a pair, and replacing both at once keeps the door balanced.
  • Door size and weight. Heavier and wider doors need stronger springs.
  • Worn parts nearby. Cables, rollers or bearings that are close to failing may be worth replacing at the same visit.

Pricing depends on the exact issue and parts needed. You will get a written price before any work starts, and nothing is added without your OK.

What to expect from Capitol Garage Door

  • Owner-operated. The owner answers the phone and does the work. No call center.
  • Price before work. You see the price first, and nothing extra is added without your OK.
  • Repair first. A spring repair is recommended when it makes sense, not a new door.
  • Safety checks included. Every spring job ends with a balance test and an opener safety check.

Where Capitol Garage Door will offer spring repair

Spring repair will be available across the region, including Elk Grove, Sacramento, Rancho Cordova, Folsom, Roseville and Wilton. See every community on the service area page.

Related problems: cable repair, garage door won’t open and urgent garage door problems.

Garage door spring questions

How much does garage door spring replacement cost?

It depends on whether one or two springs are replaced, the spring type and the size of the door. The exact price is given before any work begins.

Can I open my garage door with a broken spring?

It is not recommended. Without the spring, the door is far heavier and can fall, and the opener can be damaged trying to lift it.

Should both springs be replaced if only one broke?

Usually. Both springs have the same number of cycles on them, so the second one is often near the end of its life. Replacing both avoids a second repair soon after.

How long do garage door springs last?

It depends on how often the door runs and whether the springs were sized correctly. Heavy daily use wears them out faster. Higher-cycle springs are an option for busy households.

Is a broken spring dangerous?

The broken spring itself is usually done releasing energy, but the door is now unbalanced and can drop. Keep clear of the door and do not try to lift it by hand.

Launching soon. Capitol Garage Door is not booking work yet. Tell us your town and what your garage door is doing, and you will hear from us when we open.